Alert
Unfortunately, we are not able to proceed with your registration if you do not have the power to enter your company into a legally binding agreement with ENWIN.
To learn more please select a question from the list below.
In Ontario, the maximum acceptable concentration (MAC) for lead is 0.010 mg/L. (O.Reg 169/03)
The Canadian guideline for lead in drinking water is 0.005 mg/L.
The City of Windsor continues to be well served with water that consistently exceeds the guidelines set by the Ministry of the Environment, Conservation and Parks. Lead levels within the City's distribution system, samples are collected quarterly and have historically returned values less than 0.001 mg/l, much lower than the regulated level set by the Ministry.
If your house was constructed prior to 1948 there is a possibility that the service line from the watermain to your house was constructed from might be lead.
To determine if your service is lead, locate your water meter (typically located in the basement) and inspect the pipe coming through the exterior wall or basement floor into the meter. If you lightly abrade the pipe, using sandpaper or a dull edged knife, and the metal scratches easily, leaving a metallic shiny surface, then there is a possibility that you have a lead service. To verify if the service is lead, pass a magnet over the surface of the pipe. If the magnet is NOT attracted to the pipe, then the service is likely made of lead. If the magnet is attracted to the pipe, then the service is likely galvanized pipe. If the pipe is plastic or has the colour of a copper penny when abraded, then the service is also not lead.
Windsor Utilities Commission also has an ongoing capital program that is aimed at replacing our underground infrastructure. While carrying out watermain replacement projects, whenever it is discovered that there are lead service lines conveying water from the watermain onto private property, these services are replaced from the watermain up to the property line. Additionally, the Windsor Utilities Commission will provide notice to the homeowner if a lead water service is encountered at the property line. The homeowner is encouraged to have the lead service replaced at their own cost.
Information Bulletin
Backgrounder
Amendments made by the Ministry of Environment, Parks and Conservation (MECP) to O. Reg. 170/03 under the Safe Drinking Water Act call for the implementation of an extended lead reduction strategy designed to safeguard the quality of Ontario’s drinking water.
As part of the lead reduction strategy, the Windsor Utilities Commission initiated its Corrosion Control program (phosphoric acid) on August 10, 2016. The Community Lead Sampling program is designed to monitor the effectiveness of the Corrosion Control program.
Community Lead Sampling
The program consists of:
Candidates
Windsor Utilities Commission is seeking candidates for lead sampling that are:
Proposed Target Areas:
Please Note:
Sampling Process
An ENWIN Utilities Ltd. staff member will arrange to visit your dwelling and collect two water samples. Due to COVID-19, two samples will be collected from an outside tap so that workers do not need to enter your home. These samples will then be sent to an accredited lab for lead analysis. The results will be shared with you, the MECP and the Windsor-Essex County Health Unit.
Sampling Time Frame
Sampling is conducted twice a year, in the winter and summer.
For further information regarding regulations, testing procedures or the sampling program, contact: Monica Reid, Compliance Coordinator at 519-251-7300 ext. 341.
For further information on the Safe Drinking Water Act, please visit this link.
If you would like to participate in the Community Lead Sampling Program, please contact our Call Centre: 519-255-2727 and select Option 3.